ZappBots wishes a warm welcome to everyone.

Especially our visitors from
Savage///Circuits and Parallax!!!


Please take a look our new forums, we hope you register and become an active user.

The ZappBots forums are being run on phpBB 3.1.4 software which is different then the vBulletin used on the Savage///Circuits and Parallax forums.
Therefore, things look and work a little different, especially creating posts and uploading images / attachments.


The important thing is we have a place toTalk, Learn and Showcase our projects.

Prototype Audio Controller Main Board

This is the place to talk about Analog Electronics
User avatar
Savage///Circuits
VIP
VIP
Posts: 420
Joined: Tue May 12, 2015 2:43 pm
Location: Palmyra, NY
Contact:

Prototype Audio Controller Main Board

Postby Savage///Circuits » Mon May 30, 2016 7:56 am

A Savage///Circuits Project

Category: Audio Projects
Created: Sunday, 16 August 1998
Image

Sometimes when you etch your own PCBs using resist ink you can have issues such as over or under etching the board. But I hadn't expected that my failure to clean and seal the board properly after soldering would result in oxidation eating the board away over the course of a year until my most complex hand-etched board would fail, taking my favorite and most used / enjoyed project with it.

Follow this link to read more @ Savage///Circuits: Prototype Audio Controller Main Board

Post a reply, to discuss this project, here at ZappBots
Image
I'm only responsible for what I say, not what you understand.

Return to “Analog Electronics”

Who is online

Users browsing this forum: No registered users and 2 guests