Creating some boards, anyone interested??

[jknightandkarr]

I started a project for myself, but thought that others might find it useful as well, so other designs could come, but here it is:

It's a 10-MOSFET driver board. It features 10- N-Channel IRLZ44N MOSFETs, the Gates are pulled to ground via 10k ohm resistors to prevent any undesired triggers of the MOSFETs, and spots for any 10 resistors of your choosing(or Cap or diode), just connect those to the board, the outputs of your load to Drain or if not needed to the output pins on the resistor terminals, the Gate to your switch or microcontroiler, and connect to ground. There is a ground point on each side to allow easy daisy chaining together or to something else. If needed heat-sinks should be able to be used. 0.4 in between the MOSFETs. Traces are all 20 mils wide minus ground which is 25, but is connected to ground plains on both sides, I picked the IR:Z44N MOSFETs as I saw a video from Great Scott! on YouTube and that is what he used. Thoughts on these are welcome.

[Granz]

83W, that's a lot!

https://www.infineon.com/cms/en/product ... l/irlz44n/

[jknightandkarr]

Least it won't blow that easy...

[Savage///Circuits]

This looks almost identical to my original Knight Rider Scanning Light Driver Board from 1988, which drove 12V 1156 automotive bulbs and was driven by a small logic board and later, my Z80 ACM. Nostalgic.

[jknightandkarr]

Would work for it! I am going to make my own controller sometime.