ZappBots wishes a warm welcome to everyone.

Especially our visitors from
Savage///Circuits and Parallax!!!


Please take a look our new forums, we hope you register and become an active user.

The ZappBots forums are being run on phpBB 3.1.4 software which is different then the vBulletin used on the Savage///Circuits and Parallax forums.
Therefore, things look and work a little different, especially creating posts and uploading images / attachments.


The important thing is we have a place toTalk, Learn and Showcase our projects.

Assembly of Propeller Robot Controller Kit V1.02 by Wulfden in 2011

A place to talk about anything about robots / robotics that does not fit in one of the below categories.
User avatar
zappman
Administrator
Administrator
Posts: 116
Joined: Wed May 06, 2015 12:31 am
Contact:

Assembly of Propeller Robot Controller Kit V1.02 by Wulfden in 2011

Postby zappman » Sat Jun 06, 2015 10:30 am

Originally posted on the Savage///Circuits forums on September 1st, 2011, 11:06 PM by zappman

I recently purchased a Propeller Robot Controller (Board) Kit V1.02 by Wulfden on Ebay.

The manual for the Kit can be found at http://www.wulfden.org/downloads/manuals/PRC102-2.pdf

Its been years since I have assembled a complete circuit board so I thought it would be fun to assemble this kit, and brush up on my soldering skills.

While I was at it I decided to take pictures of the build.

Below are some annotated pictures of the build of PRC Kit V1.02:

Image
Image
Image
Above Picture is actually the component side of the board

Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
butlh ghajbogh nuv'e' yIHo'.
Admire the person with dirt under his fingernails.

Return to “Robotics: General Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest