Especially our visitors from Savage///Circuits and Parallax!!!
Please take a look our new forums, we hope you register and become an active user.
The ZappBots forums are being run on phpBB 3.1.4 software which is different then the vBulletin used on the Savage///Circuits and Parallax forums.
Therefore, things look and work a little different, especially creating posts and uploading images / attachments.
The important thing is we have a place toTalk, Learn and Showcase our projects.
- Posts: 116
- Joined: Wed May 06, 2015 12:31 am
Here are the main differences between the R3 and previous versions:
The USB controller chip has been upgraded from an ATmega8u (8k of flash memory) to an ATmega16u (16k of flash memory.) This new chip should make it easier to emulate input devices like joysticks, mice, MIDI interfaces, and keyboards (this has not yet been tested and there is no code yet.)
Analog pins 4 and 5 have been broken out next to the AREF pin to allow for I2C communication. This makes it easier for future shields to be compatible with both UNO’s and MEGA’s. Also, the power pin has been duplicated next to the RESET pin to let shields know what voltage they are running (in the case of the UNO it’s 5 volts.)
The reset button has moved next to the USB input for easier accessibility while a shield is in place.
Arduino Uno Rev3 Back with 4 new pins circled in red.
Arduino Uno Rev 3 Schematic with 4 new pins highlighted in red.
This picture shows the dimensions of the pin locations of the 4 new pins on the Arduino Uno R3
butlh ghajbogh nuv'e' yIHo'.
Admire the person with dirt under his fingernails.
Users browsing this forum: No registered users and 1 guest