Page 1 of 1

Assembly of Propeller Robot Controller Kit V1.02 by Wulfden in 2011

Posted: Sat Jun 06, 2015 10:30 am
by zappman
Originally posted on the Savage///Circuits forums on September 1st, 2011, 11:06 PM by zappman

I recently purchased a Propeller Robot Controller (Board) Kit V1.02 by Wulfden on Ebay.

The manual for the Kit can be found at http://www.wulfden.org/downloads/manuals/PRC102-2.pdf

Its been years since I have assembled a complete circuit board so I thought it would be fun to assemble this kit, and brush up on my soldering skills.

While I was at it I decided to take pictures of the build.

Below are some annotated pictures of the build of PRC Kit V1.02:

Image
Image
Image
Above Picture is actually the component side of the board

Image
Image
Image
Image
Image
Image
Image
Image
Image